Вот с соседнего форума инструкция на Xprog. Попробуйте натянуть тоже самое, т.е запитать плату или проц, и указать верно кварц.
1) give +12v (all the pins needed) and gnd to ecu
2) connect to HC11F1 using THESE x-prog schematics like in attachment (should be 7 wires)
3) MOST IMPORTANT: in xprog configuration use THE SAME OSCILLATOR FREQUENCY LIKE IN OSCILLATOR ONBOARD (4mhz,8mhz,16mhz...)
4) select of course HC11F1 in DEVICE SELECTION
I had to do some tries, but this method work ALWAYS, without detaching anything.
bye
1) give +12v (all the pins needed) and gnd to ecu
2) connect to HC11F1 using THESE x-prog schematics like in attachment (should be 7 wires)
3) MOST IMPORTANT: in xprog configuration use THE SAME OSCILLATOR FREQUENCY LIKE IN OSCILLATOR ONBOARD (4mhz,8mhz,16mhz...)
4) select of course HC11F1 in DEVICE SELECTION
I had to do some tries, but this method work ALWAYS, without detaching anything.
bye
