med17.1.6 porsche hybrid

[spapsit]

Hello, does anyone happen to have a complete (eeprom and flash) of med17.1.6 from a porsche cayenne hybrid 2013.I corrupted my eeprom.

 

[El-kostroma]

Hello, does anyone happen to have a complete (eeprom and flash) of med17.1.6 from a porsche cayenne hybrid 2013.I corrupted my eeprom.

Есть фулл от реста

 

[spapsit]

Посмотреть вложение 309305

There is a full resto

Thank you boss, i will try to repair my eeprom with it.

 

[El-kostroma]

Thank you boss, i will try to repair my eeprom with it.

If you need help transferring immobilizer data, feel free to reach out — I can assist.

 

[spapsit]

Hello, boss..i have tried everything i know of but not working.I have attached both front and rear BCM d flash and the current file i have for ecm.
Am still getting DME Confirmation failed.
Please assist if you have time.
Regards.

 

[El-kostroma]

Hello, boss..i have tried everything i know of but not working.I have attached both front and rear BCM d flash and the current file i have for ecm.
Am still getting DME Confirmation failed.
Please assist if you have time.
Regards.

Это фулл для ЭБУ под ориг, для записи вашего донорского блока нужно будет подготовить перенос иммо-данных отдельно от этого - иначе нихера не выйдет

 

[spapsit]

Thank you,let me get to it

 

[spapsit]

Thank you, let me get to it

Посмотреть вложение 309352
Посмотреть вложение 309353

This is a full set for the ECU under the original. To write your donor unit, you will need to prepare the immobilizer data transfer separately from this one - otherwise, nothing will work.

This file worked like a charm...i'll make sure i reward once the vehicle is done....but now the vehicle is not starting because of immo p15700 in high voltage electronics.P157000 High-Voltage Power Electronics Control Unit Blocked - No Communication With Front-End Electronics....now i think its the slave ecu.Now i dont have the idea of a way to bench read the hybrid inverter.

te

 

[El-kostroma]

te

You have a V6, which uses a single control unit—I’ve already transferred the immobilizer data from your original unit to it.
As I mentioned, you need to prepare the (donor) unit so that it’s ready for the files I sent (I created these based on the original files). You can’t just write them directly; the immobilizer data must be transferred.

 

[spapsit]

You have a V6, which uses a single control unit—I’ve already transferred the immobilizer data from your original unit to it.
As I mentioned, you need to prepare the (donor) unit so that it’s ready for the files I sent (I created these based on the original files). You can’t just write them directly; the immobilizer data must be transferred.

i get you and the engine immobiliser system is correct and working..also the ecu was vehicles original and only the eeprom was corrupted.But now there is an issue with high voltage electronics module giving P157000 High-Voltage Power Electronics Control Unit Blocked - No Communication With Front-End Electronics...as you can see from the errors given, the error is not in ecm but in hv module.